Product Description:

• 
  

  The Kent Shaving Set is an elegant and refined essential that encompasses all your basic necessities.

  
  


• 
  

  Includes a high-quality blended bristle brush to evoke the softness and luxury of a smooth wet shave.

  
  


• 
  

  Embedded with shaving cream, apply the desired amount onto the brush to produce the lather that you need.

  
  


• 
  

  Helps moisturize and condition skin so that you don't have inflamed skin.

  
  


• 
  

  Has a black acrylic stand so that the brush can be dried at a proper angle.

  
  

Product Features:

• The overall length of the brush is 105mm.


• Width at base of knot 19mm.


• Stand Height 75mm.


• Shaving Cream SCT1 75mm.


• Black Acrylic Stand.

How To Use:

A first rate shave is all about preparation and the right tools for the job. By following the process below, you will experience the ultimate shave:The Shave:

• Shave after the shower or wrap a hot soaking wet face towel across the face for 30 seconds.


• The hot water loosens the pores, the bristles of the beard swell, which also become soften


• Run your shaving brush under a hot tap until the head becomes heavy with water and shake out about two thirds. Too much water dilutes the shaving cream and if you are using shaving soap inhibits building up a good lather.


• Flick you brush across the soap bowl, rather than go around in circles. Badger hair is fine and the latter process will eventually wind the bristles tighter and tighter and cause them to snap or fall out.


• If using cream dip the brush into this and lather the skin in an upward motion.


• Hot steel cuts better than cold steel, so run your razor under a hot tap.


• Shave with the grain of the beard or stubble – generally a downward direction.


• As long as the blade is changed regularly (suggest once per week) the razor will glide along the skin with minimal pressure.


• For an extra close shave or stubborn growth re-apply lather and shave sideways across the skin in short strokes, again with minimal pressure.


• Rinse the face with clean water to close the pores and pat the skin dry, applying a suitable moisturiser.


• Rinse both razor and brush under the tap and shake off excess water.


• To prolong the life of the brush, turn upside down and place on a stand to prevent water settling in the base.