The wortie Advanced warts and verruca remover is designed to treat stubborn and mature warts for patients aged 12 years and older.
These mature warts often have a thicker layer of hard skin which can be more difficult to penetrate than younger warts.
The conductive gel maximizes the performance by directing the cold temperature onto the application area.
The tip of the Wortie Advanced Wart & Verruca remover is flat to maximize the contact with the wart for highly effective removal of stubborn warts.
How To Use:
In most cases, only one treatment is needed for each wart.
Consult your general practitioner if three treatments have not led to improvement.
After Wortie is applied wait 14 days for the wart to fall off.
In case the wart hasn’t changed within this time,you can apply Wortie a second time. Always wait 14 days between applications.
Clean the applicator with alcohol on a small piece of cloth after each application. Allow the metal tip to reach room temperature after each application before reactivating for use on other warts.
Instructions Of Use:
Gently squeeze the gel tube to apply one single drop of the conductive gel exactly on the wart Remove the cap and place the can upright on a table or flat surface.
Keep the can in the vertical position; put the cap back aligning the arrow icon of the cap with the freeze icon of the can.
Press the cap down for 3 seconds (DO NOT EXCEED 3 SECONDS).
You will now hear the activation sound(hiss). Precisely apply the frozen metal tip on the common wart (hand) for 20 seconds and for verruca (foot) 40 seconds
In case of particularly verruca or sensitive skin (if you experience difficulties walking after treatment), a foam plaster can be used to protect the tender plantar wart area after treatment has been completed.
Carefully remove foam plaster from backing.
Apply adhesive side of foam plaster to skin with hole directly over the small tender spot.
Clean the tip and put the cap back in close position and wait 14 days for the wart to go away.
Caution & Warnings:
Extremely Flammable.
Content under pressure.
Do not pierce or burn aerosol spray can, even after use.
Keep away from heat/sparks/open flames/hot surfaces - No smoking. Do not spray near an open flame such as candles or other ignition source. Do not expose to temperatures exceeding 50 Deg C/122 Deg F. Protect the device from sunlight and store in a dry and cool place.
Piercing the container or exposure to the heat may cause the container to explode, causing serious injury.
Avoid Contact with Eyes. Contact with eyes may cause blindness.
If the product gets into the eyes, flush with water for 15 minutes and seek medical help immediately.
Children cannot understand the instructions on how to properly use this product.
The wortie Advanced warts and verruca remover is designed to treat stubborn and mature warts for patients aged 12 years and older.
These mature warts often have a thicker layer of hard skin which can be more difficult to penetrate than younger warts.
The conductive gel maximizes the performance by directing the cold temperature onto the application area.
The tip of the Wortie Advanced Wart & Verruca remover is flat to maximize the contact with the wart for highly effective removal of stubborn warts.
How To Use:
In most cases, only one treatment is needed for each wart.
Consult your general practitioner if three treatments have not led to improvement.
After Wortie is applied wait 14 days for the wart to fall off.
In case the wart hasn’t changed within this time,you can apply Wortie a second time. Always wait 14 days between applications.
Clean the applicator with alcohol on a small piece of cloth after each application. Allow the metal tip to reach room temperature after each application before reactivating for use on other warts.
Instructions Of Use:
Gently squeeze the gel tube to apply one single drop of the conductive gel exactly on the wart Remove the cap and place the can upright on a table or flat surface.
Keep the can in the vertical position; put the cap back aligning the arrow icon of the cap with the freeze icon of the can.
Press the cap down for 3 seconds (DO NOT EXCEED 3 SECONDS).
You will now hear the activation sound(hiss). Precisely apply the frozen metal tip on the common wart (hand) for 20 seconds and for verruca (foot) 40 seconds
In case of particularly verruca or sensitive skin (if you experience difficulties walking after treatment), a foam plaster can be used to protect the tender plantar wart area after treatment has been completed.
Carefully remove foam plaster from backing.
Apply adhesive side of foam plaster to skin with hole directly over the small tender spot.
Clean the tip and put the cap back in close position and wait 14 days for the wart to go away.
Caution & Warnings:
Extremely Flammable.
Content under pressure.
Do not pierce or burn aerosol spray can, even after use.
Keep away from heat/sparks/open flames/hot surfaces - No smoking. Do not spray near an open flame such as candles or other ignition source. Do not expose to temperatures exceeding 50 Deg C/122 Deg F. Protect the device from sunlight and store in a dry and cool place.
Piercing the container or exposure to the heat may cause the container to explode, causing serious injury.
Avoid Contact with Eyes. Contact with eyes may cause blindness.
If the product gets into the eyes, flush with water for 15 minutes and seek medical help immediately.
Children cannot understand the instructions on how to properly use this product.